Aquael AQUAJET PFN 1500 Water Pump – 1500L/h
Now $109.95
FREE SHIPPING on all orders over $150 Exclusions Apply
Shop aquarium water pumps, sump return pumps, controllable DC pumps, pond pumps and solar pump kits. Compare flow, maximum head, plumbing connections and installation method for the job.
Maximum litres per hour is not the same as installed flow. Height, hose length, diameter, bends, valves and connected equipment can all reduce delivery. Aquaholics ships pumps Australia-wide.
Aquael AQUAJET PFN 1500 Water Pump – 1500L/h
Now $109.95
Start with the flow required at the actual operating head. A pump’s maximum flow is generally measured under low-head conditions, while maximum head is the point near which usable flow approaches zero—not the recommended working height.
A return pump must deliver the required flow after lifting water from the sump and pushing it through the plumbing. Adjustable DC models can help tune output, but the selected pump must still meet the operating head.
Pond pumps may power circulation, filtration, waterfalls or fountains. Each application has different head and solids-handling needs; a fountain head or accessory listing is not itself a pump.
Solar output changes with sunlight unless a supported battery system is present. Electronic control can reduce pump output within the product’s operating range, but it cannot make an undersized pump overcome excessive head.
Install the pump with the specified intake clearance, plumbing and electrical protection. Never run a pump dry unless the manufacturer explicitly permits it.
Disconnect power before servicing. Clean the impeller, intake and housing as directed, inspect seals and hoses, then confirm normal flow and no leaks after restart.
Compare pond pumps, solar pumps, controllable pumps and DC pumps.
Compare current pumps by flow at head, maximum head, energy use, inlet and outlet size, installation type and warranty. Order online across Australia or get local Sunshine Coast support.
It states a flow rate, often the maximum under low-head test conditions. Installed flow is usually lower once lift and plumbing resistance are added.
It is the approximate height at which the pump can no longer produce useful flow. It is not the recommended normal operating height.
Estimate the required return flow, calculate vertical lift and plumbing losses, then use the manufacturer’s flow-versus-head information.
No. Use a pump externally only when the manufacturer explicitly allows that installation.
A blocked intake, dirty impeller, clogged plumbing, restricted valve or added head can reduce flow. Disconnect power and inspect it according to the manual.